The orders table contains all created orders and their information. You can find the orders table in the “Orders” section.

Orderry allows you to configure orders table columns, so you only see the needed order-related data.

Hit the table icon in the upper right corner to add or remove table columns by checking the column checkboxes.

Note: You cannot remove the “Checkbox” and “Order №” system columns of the orders table.

Adjust the column width by dragging the right column border. Swap columns in the table by grabbing the needed one and dragging it to the desired position.

Sort your orders by a specific column. Press the column header and select between ascending and descending sorting (up arrow and down arrow icons respectively). If you need more sophisticated order sorting, use the order filter.

Use the “Checkbox” column to select or cancel selecting of all orders on the page for bulk order actions. Hit the order number to open an order window. Click the status name to switch status for a selected order without going to the order page. Press the client's name to open the client dialog window, where you can call clients or send them SMS messages (if you have integrated the IP-telephony and SMS gateway).

The “Order deadline” column displays the remaining time for order fulfillment and the order deadline.

Your orders become overdue and get an overdue icon (filled clock) if you don't transfer them to the “Completedstatus before the deadline comes.

Find the remaining status time limits duration in the “Status deadline” column. This column gets a lightning icon if you overdue your order by status. In that case, you can see the negative time value — it's overdue-by-status time.

Note: you can set and monitor the status time limits in the Subscription Plans “Business” and greater.

Use badges to view only overdue-by-date or overdue-by-status orders.

Filter your orders by location. You can switch between locations by selecting the needed one from the dropdown list on the top of a page. 

Find out more about adding and configuring locations here.

Did this answer your question?